High quality fixed table press

The maintenance of high quality fixed table press is an important link to ensure its stable operation, extend its service life, and improve production efficiency. The following are maintenance recommendations for fixed press machines from the aspects of daily maintenance, regular inspection and maintenance, as well as safe operation and protection:

1. Daily maintenance

1. Cleaning and lubrication:

Regularly clean the surface and interior of the fixed table press to remove oil, dust, and debris. Check and add lubricating oil to ensure that all transmission, connection, and friction parts are fully lubricated.

2. Inspection and adjustment:
Check if the fasteners of the punch press are loose, and tighten them promptly if they are loose. Adjust the transmission mechanism of the high quality fixed table press to ensure smooth movement and no jamming phenomenon. Check the installation and fixation of the mold to ensure that the mold pressing block is firmly and reliably fixed on the machine, the upper and lower molds are aligned, and the position is correct.
3. Electrical system maintenance:

Check if the electrical circuit is intact, without any damage or exposure. Check if the electrical components are working properly and replace them promptly if they are damaged.

2. Regular inspection and maintenance

1. Transmission system inspection:
Regularly check the operation of transmission shafts, copper sleeves, bearings, and other components. If there are any abnormalities, they should be disassembled, oiled, or replaced in a timely manner. Check the wear of the transmission mechanism and repair or replace it if necessary.
2. Inspection of control and braking system:
Check whether the manipulator, clutch, brake and other components are working properly. If there are any abnormalities, they should be adjusted or replaced in a timely manner. Regularly check the air pressure system of the high quality fixed table press to ensure stable air pressure and no air leakage.
4. Inspection of molds and stamping parts:

Check the wear of the mold, and replace it promptly if there is severe wear. Check the deformation and damage of stamped parts, and repair or replace them promptly if there are any abnormalities.

3. Safe operation and protection

1. Operating standards:
Fixed table punch operators must undergo learning, master the structure and performance of equipment, be familiar with operating procedures, and obtain operating permits before they can operate independently. When operating the punch press, it is necessary to strictly follow the operating procedures to avoid equipment damage or personal injury caused by improper operation.
2. Safety protection:
Ensure that the protective devices of the punch press are intact and effective, such as protective covers, safety doors, etc. When operating a fixed table press, personal protective equipment such as work clothes, protective gloves, safety helmets, etc. should be worn.
3. Emergency handling:
When there is abnormal noise or other abnormal phenomena during stamping work, the emergency stop switch should be immediately pressed to stop the work and the main power switch should be disconnected. If equipment failure or personal injury accidents occur, they should be reported immediately and emergency measures should be taken.
In summary, the maintenance of high quality fixed table presses needs to start from multiple aspects such as daily maintenance, regular inspection and maintenance, as well as safe operation and protection. Through comprehensive maintenance and upkeep, the stable operation, extended service life, and improved production efficiency of the punching machine can be ensured.